Damaged card

Un log shield sur carte SD avec horloge RTC et zone de prototypage à pastilles carrées

Damaged card

Message non lude Lenny » Mar 22 Nov 2011 12:34

I would like to know how to remove the the card from connector without risk to damage it.
I've already damaged an SD removing it without unplug the usb supply from Arduino.

Messages: 1
Inscription: Mar 22 Nov 2011 12:29

Re: Damaged card

Message non lude Stéphane » Mar 22 Nov 2011 13:02


First, to avoid damaging the file system, be sure to close the file thread before remove the card.
Then, on an electric way, the safest way is to unplug the USB or push the reset button. But SD cards are hot plug ready, so normally, there is no problems on this side.
The first point is the most important.

Have a good day :)
Avatar de l’utilisateur
Messages: 179
Inscription: Lun 2 Mai 2011 09:40

Retourner vers Mémoire

Qui est en ligne

Utilisateurs parcourant ce forum: Aucun utilisateur enregistré et 1 invité