Page 1 sur 1

Damaged card

Message non luPosté: Mar 22 Nov 2011 12:34
de Lenny
Hi,
I would like to know how to remove the the card from connector without risk to damage it.
I've already damaged an SD removing it without unplug the usb supply from Arduino.

Regards.

Re: Damaged card

Message non luPosté: Mar 22 Nov 2011 13:02
de Stéphane
Hi,

First, to avoid damaging the file system, be sure to close the file thread before remove the card.
Then, on an electric way, the safest way is to unplug the USB or push the reset button. But SD cards are hot plug ready, so normally, there is no problems on this side.
The first point is the most important.

Have a good day :)